Blue Tension Meter Screen Tensiometer

Screen Tensiometer

Model: TITAN

The ITAN screen tension meter has been calibrated to zero before leaving the factory. 

Users do not need to adjust it by themselves.

The tension of the net is expressed in N / cm, which indicates how much the tensile force of the mesh yarn per cm width is usually expressed in N-Newton or Kg-kg. 

Newton shows the actual meaning of the tensiometer; the reading display method: 

The first reading of the tensiometer reading is incorrect. The second reading of the tensiometer is normal and the tensiometer should be flicked. Mesh next to it.

TITAN tension meter is suitable for the measurement of various screen tension, Pointer indicating tension, unit: N/CM. The tension at any place of the tensioned cloth can be detected, the radial tension and weft tension of the measured screen can be distinguished, make the screen to reach the same tension in the latitude and longitude direction. TITAN tension meter is a precision instrument, it needs to be kept dry and idust-free, and need to pay attention to anti-fall and anti-shock.

1. Zero adjustment disc

2.0 N / cm (zero point)

3. Glass calibration block

4. Induction device

Zero adjustment

Before using the tensiometer to calibrate the tension meter, place the tensiometer on the front of the zero adjustment plate(Do not use too much effort),Turn the scale lock counterclockwise by hand until the scale disc rotates.Rotate the dial until the dot is pointing to the pointer, and then turn the scale lock clockwise to lock the scale.

(Note: 1. Scale in the zero when the long needle is not necessarily and the horizontal line into 90 degrees, left partial right is normal.2. Daily use, such as zero adjustment plate appears large gap or broken should be replaced.

Measuring

The steel mesh or screen plate non-printed surface up on the platform.

The entire tension meter on the smooth side of the outer frame 15-20cm on the net surface.With a finger to tap the stencil or wire mesh surface a few times, then the pointer is the point of view of the current stencil or wire mesh on the actual tension 

(Newton readings).Place the steel screen or screen version horizontally (PCB contact or screen print side up),Place the tension meter in the steel mesh or screen version of the four corners and center, check the point of the tension value, and the minimum value fill (stencil or screen use resume).Check whether the measured value of steel mesh or screen tension is within the allowable range , if the measured value is not standard, the feedback engineer handles.

Note

When testing the tension, the wire mesh must be suspended;

The tensiometer needs to be zeroed before use.

It is forbidden to add lubricant to any part.

Pay attention to shock. If the instrument is dropped, it may damage or reduce the 

measurement accuracy and sensitivity.